Environmental Chamber

GENERAL INFORMATION FOR OFFERORS

Please read the following carefully. Sections B through M may not be in sequential order. Please read the

solicitation and attachments in its entirety. Some clauses and/or provisions may appear out of sequence or in the

incorrect area of the solicitation; however, the clauses or provisions still apply. In the event a clause or provision

is not applicable, the clause or provision becomes self-deleting. All provisions become self-deleting at the time of

award.

1. DESCRIPTION: This is a requirement for maintenance, repair, software installation, and calibration services for

multiple manufacturer environmental chambers. The contractor shall provide all labor, tools, transportation, supplies,

supervision, assembly, etc. (except as noted), necessary to accomplish this acquisition to the DLA, Product Test

Center Division, in Columbus, Ohio. Details and specifications of the equipment needed for this acquisition are

identified in Att 1 PWS Environmental Chamber.

2. QUOTE SUBMISSION: Quotes are due by 3:00 PM Eastern Standard Time (EST) on the date specified in Block 8 of Page 1.

Quotes are considered late after 3:00 PM EST. The following method of submitting a quote is as follows:

EMAIL QUOTES TO: Blair.Hartley@dla.mil. Emailed quotes cannot exceed 15 MB. E-mailed quotes greater than 15 MB must be

divided into multiple emails. USE SUBJECT: Environmental Chambers

Offerors are responsible for submitting quotes, and any revisions, to reach the Government office designated in the

solicitation by the date and time specified.

3. POINT OF CONTACT: For solicitation information, please see the point of contact listed in Block 7 of the SF1449.

4. CONTRACT LINE-ITEM NUMBER (CLIN): The item/supply will be listed as a CLIN in Section B.

5. PROCUREMENT ITEM DESCRIPTION (PID): PID information is not available. A description of the supply/product is

provided in Att 1 PWS Environmental Chamber.

6. QUANTITY (Qty): The number of units required is provided in Att 1 PWS Environmental Chamber.

7. ITEM NUMBER OR PART NUMBER OFFERED (Offeror Fill-in): Offerors shall include either the item number or the part

number for CLIN 0001 quoted in Section B if applicable.

8. UNIT PRICE AND TOTAL (Offeror Fill-in): Offerors shall include the unit price and the total price for CLIN 0001

quoted in Section B.