SOURCES SOUGHT - Clarifier Oil Water Separator

Vendor must provide:

SPT-10-E - Clarifier Separator System or other government approve equal and must conform to the following specifications:

• 1-10 GPM Clarifier Separator with Electric Pump & Control, 120V


• Approximate dimensions: 7’L x 2’6” W x 4’-10” H


• 1-10 GPM Above Ground Clarifier Oil/Water Separator with Sludge Hopper


• Stainless Steel Construction


• 30-gallon on-board oil storage tank


• Advanced coalescing media designed to remove oil droplets greater than 20 microns with a Reynolds Number of less than 500 to maintain laminar flow


• Stainless Steel inclined plates to capture and contain settable solids


• Solids storage area


• Single adjustable rotatable pipe skimmers and 120V disk skimmer with timer


• Neoprene gasketed removable vapor tight cover for access to chamber compartments


• 2” Inlet/Outlet- FNPT Fitting and two (2) 2” Oil Outlet-FNPT Fitting


• Two (2) 2” Vent NPT Fittings to vent unit outside, two (2) 2” Sludge drains and two (2) 1” Drain NPT Fittings


• Effluent compartment for pump out


• (1) Electric 10 GPM Diaphragm Transfer Pump System with Electric Controller


• Gravity drain

One (1) Corrosion Protection Package with:

• Separator Interior lined with Tnemec 61, 8-10 mils