Generator Purchase, Removal and Installation

Location:	Nebraska
Posted:	Jun 10, 2026
Due:	Jul 8, 2026
Agency:	State Government of Nebraska
Type of Government:	State & Local
Category:	S - Utilities and Training Services
Publication URL:	To access bid details, please log in.

ITB 122828 ORAGENCY:

State Purchasing Bureau

PROCUREMENT CONTRACTS OFFICER(S):

Brenda Sensibaugh, Kelly Rowlands

Phone: 402-471-6500 Email: as.materielpurchasing@nebraska.gov

OPENING DATE:

July 8, 2026 at 2:00 PM CST

The bid opening will occur in accordance with the Schedule of Events detailed in the solicitation linked below.

PROJECT DESCRIPTION:

The State of Nebraska (State), Department of Administrative Services (DAS), Materiel Division, State Purchasing Bureau (SPB), is issuing this solicitation for the purpose of selecting a qualified Bidder to provide Generator Purchase, Removal and Installation.

Written Questions regarding the project are due no later than June 22, 2026.

Project Documents	Date Posted	Document Format(s)
Invitation to Bid:	06/10/26	Word
Cost Sheet:	06/10/26	Excel
Attachment A:	06/10/26	PDF
Attachment B:	06/10/26	Excel

Attachment Preview

122828 OR ATTACHMENT A

GENERATOR ACCEPTANCE TEST FORM DOCUMENT

Section 1: Site Demographics

• Site Location/Name: __________________________

• Purchase Order: __________________________

• Date of Test: __________________________

Removed Asset

• Property of State of Nebraska Tag Number: __________________________

• Manufacturer: __________________________

• Model: __________________________

• Serial Number: __________________________

Installed Asset

• Property of State of Nebraska Tag Number: __________________________

• Manufacturer: __________________________

• Model: __________________________

• Serial Number: __________________________

Section 2: Pre-Start Inspection Checklist

Check all that apply. If "Fail," provide a remediation note.

Inspection Point

Pass Fail Notes/Comments

Coolant Level/Concentration ☐ ☐

Oil Level/Quality

☐☐

Fuel Level (100% Full)

☐☐

Battery Voltage (>12.6V)

☐☐

Belts & Hoses Tension/Wear ☐ ☐

Block Heater Functioning

☐☐

Battery Heater Functioning ☐ ☐

Remote Monitoring

Functioning

☐☐

Section 3: Load Test Data (60-Minute Run)

Time Voltage (L-L) Frequency (Hz) Load (%) Oil PSI Water Temp

Start

15 Min

30 Min

45 Min

60 Min

Section 4: Control System & Safety Verification

Verify the following safety parameters trigger correctly:

• [ ] Emergency Stop: Unit shuts down immediately when pushed.

• [ ] Remote Start: Unit engages via ATS signal.

• [ ] Fault Reset: Alarms clear properly on the control panel.

• [ ] Automatic Mode: Controller left in "AUTO" position after test.

Section 5: Final Sign-Off

Technician Certification:

I certify the above tests were performed according to manufacturer specifications.

• Signature: __________________________ Date: __________

Submit the completed “Generator Acceptance Test Form Document” to the Public Safety

Communications Department manager.

This is the opportunity summary page. It provides an overview of this opportunity and a preview of the attached documentation.