Corrosion Control Facility Filter Replacements

SOLICITATION AMENDED 27 JUNE 2025:

The purposed of this amendment is to attach a revised version of the SOW. The original SOW included part: AJ Dralle ME/PT - 24” x 24” Panel Filter, UOM:EA QTY: 320. This part has been swapped for part: 24x24 ST-6 24/Case AJ Dralle 24” x 24” Panel Filter, UOM: EA QTY: 15.

Please closely follow the instructions for quote submission on the attached and updated Combined Synopsis Solicitation.

The Air Force has a requirement for the purchase and installation of corrosion control facility filters in accordance with the attached Statement of Work.

The primary objective of this statement of work is to provide an outline of the Stage 1 filter change required for the Corrosion Control Facility in accordance with permit #1770-RV3 and the manufacturers recommended preventive maintenance and standard commercial practices for the paint booth with the following items.

Vendor shall provide supervision, personnel, maintenance equipment, transportation, tools, and labor necessary to remove the old Stage 1 filters and install the new Stage 1 filters noted above as prescribed in this SOW. The vendor will provide all required safety equipment. All equipment used under this contract shall meet all OSHA, EPA, and any other applicable guidelines. All safety equipment must be used for its intended and designed purpose. Unsafe acts by the vendor will be reported to vendor supervision and 377 MSG and may be grounds for contract termination.