One (1) New 58,000 lbs. Tandem Axle Truck with Dump Body

Location:	Wyoming
Posted:	Sep 2, 2026
Due:	Sep 17, 2026
Agency:	City of Casper
Type of Government:	State & Local
Category:	23 - Ground Effect Vehicles, Motor Vehicles, Trailers, and Cycles
Publication URL:	To access bid details, please log in.

Attachment Preview

CITY OF CASPER

FLEET MAINTENANCE DIVISION

CITY OF CASPER

(307)235-8410

FY27026

Notice is hereby given that the City of Casper, Wyoming will receive sealed bids at the Fleet Office,

Casper Service Center, 1800 E. “K” Street, Casper, Wyoming, until 3:00 p.m., September 17, 2026 for the

following:

ONE (1) NEW 58,000LBS. TANDEM AXLE TRUCK WITH DUMP BODY

This Unit will be used by the CPU Division of the Public Services Department; unit must have the minimum

specifications of:

General

Specifications:

It is the intent of these specifications to specify the minimum requirement for the

furnishing and delivery of one (1) new 58,000lbs. Tandem Axle Truck with Body.

This unit shall be new and have less than fifty (150) hours and be less than twelve

months old, with full factory warranty. Unit shall be delivered complete and ready for

service, as specified, and shall be equipped with all of the manufacturer’s standard

equipment, as advertised, whether or not specifically mentioned in these specifications,

in addition to all other equipment and attachments specified herein.

ITEM

TRUCK

CAB/CHASSIS

1. GVW

2. Wheel Base

3. Cab to Trunnion

MINIMUM SPECIFICATIONS

BIDDERS SPECIFICATIONS

58,000 pound minimum. CERTIFIED

GVW. Severe duty application model

only.

Shall be compatible with 15' dump

body.

200-205” wheel base, or as is required

by Dump Box Installer to achieve

required CT.

Equipment supplied shall provide

proper weight distribution when truck is

loaded.

Usable 132" or shall be compatible with

a 15' dump body as bid.

It shall also provide proper weight

4. Frame

5. Diesel Engine

distribution when truck is loaded.

Minimum 110,000 psi double channel

rails, 3,200,000 RBM.

2025 model year production diesel

engine equipped with SCR technology.

DEF tank located LH side in front or

behind the fuel tank.

425 gross horsepower minimum. 1550

lb/ft. torque. 12.5 liter minimum.

Engine brake only, exhaust brake not

acceptable.

Air Cleaner - heavy-duty dry type

DPF filter located right hand side under

cab with control auto in motion,

stationary manual inhibit & auto

stationary w/PTO engaged.

Davco, Model 382, fuel/water heater

separator or comparable.

Warning System - high water

temperature; low water, low air, low oil

pressure buzzer in addition to gauges,

and lights, automatic shutdown.

Cold weather starting aid

Provision. 120v, 1500 watt block

heater.

6. Cooling System

7. Transmission

8. Axles

Coolant hoses - shall be Gates Blue

Stripe rubber including heater hoses.

Heavy-duty 1500 square inch minimum

radiator shall be protected to minus 34

degree F with year round coolant. An

integral transmission cooler shall be

provided if needed.

6-speed fully automatic Allison

4500RDS.

Front - 18,000 lbs. capacity (minimum),

Meritor FL-941, or equal.

Front axle setback 48" minimum.

______________________

Rear - 40,000 lbs. capacity (minimum). _______________________

9. Springs

10. Tires and Rims

Double reduction rear end capacity with

interaxle power divider lockout. Power

divider lockout with indicator light,

buzzer and manual valve in cab. 4.10, or

close approximation, minimum gear

ratio.

Front - 18,000 lbs ground capacity

(minimum) springs.

Rear - 40,000 lbs ground capacity

(minimum). Spring suspension equal to

Mack Camelback.

Front – 315/80R22.5 20-ply Goodyear

G296, or comparable, on 22.5 x 12.25

10-Hub Pilot aluminum disc wheels.

Rear - 11R 22.5 16-ply Goodyear G622,

or comparable, on 22.5 X 8.25 10-Hub

Pilot aluminum disc wheels.

Spare tires and wheels (each unit). One

(1) front and one (1) rear.

Note: Tires and rims are to meet the

required GVW rating.

11. Brakes

12. Cab

Dual air brakes system, cam brakes with

dust shields automatic slack adjusters,

cast iron brake drums, compressor and

accessories as required to meet all

Federal Motor Vehicle Safety

Standards.

Shall have a low air pressure buzzer and

light in cab. Also a Meritor Wabco

heated air dryer. Air tanks shall be DOT

approved with petcock drain valves and

will be steel.

Heated air supply tank with automatic

drain valves.

Air compressor – shall be a minimum

18.7 CFM.

Two man cab with outer grab handles

for ease of ingress and egress on both

driver and passenger sides.

13. Steering

14. Fuel Tank

Air suspension cab.

Driver seat will be a high quality

Bostrom Air – 915 vinyl air suspension

seat or equal. High back. Air Lumbar.

Suspension cover. Arm rests. Motion

dampening. Seat Cover added

Passenger seat will be padded with air

foam and covered with heavy-duty

vinyl. Fixed base. High back.

Seat cover added

Radiator protection screen.

Shall have steps into cab on both left

and right side.

Insulated floor mats.

Insulated cab, roof, panels, doors, rear

panel.

Safety glass in all windows.

Power door locks and windows.

RH visibility window in door or equal.

Arm rests left and right on doors.

In cab power point.

Driver, passenger seat belts.

Dome light door operated, left and right

doors.

AM/FM/WB radio with cab mounted

antenna (NO MIRROR MOUNT).

Front mud flaps.

Exterior cab sun visor, painted same as

cab.

Steering shall be heavy-duty power

steering with auxiliary gear (RCH 45 or

equal).

Turning radius not to exceed 34 feet.

Left side mounted aluminum 90 gallon ______________________

15. Electrical

minimum capacity DOT approved with ______________________

shut off valve. DEF tank to be mounted ______________________

in front of fuel tank.

______________________

12 volt negative ground.

160 amp alternator (minimum).

Three, 1000 each, C.C.A. batteries.

Five amber marker lights on cab.

Dimmer switch on steering column.

Self-canceling turn signals with four-

way emergency flashers or equal.

Back-up Alarm to be mounted to back

of truck

Three sets of keys.

16. Mirrors

Dual west coast (7" x 16") RH & LH

heated mirrors with RH & LH remote

control. 6” to 8” convex mirrors

mounted to primary mirror brackets. 4

way powered moto mirrors.

17. Exhaust System

18. Gauges In Cab

To be single vertical pipe with muffler

and proper protection to prevent burns

(exhaust shield). Mounted on right-hand

side of cab with proper exhaust

extension.

Oil pressure in dash.

Amp meter or volt meter in dash.

Air restriction indicator in dash.

Water temperature in dash.

Transmission temperature in dash.

Hour meter in dash.

Air pressure (dual) in dash.

This is the opportunity summary page. It provides an overview of this opportunity and a preview of the attached documentation.

Description	Opening Date/Time	Closing Date/Time
One (1) New 58,000 lbs. Tandem Axle Truck with Dump Body	September 02, 2026 8:00 AM	September 17, 2026 3:00 PM

One (1) New 58,000 lbs. Tandem Axle Truck with Dump Body

Attachment Preview

See also