CGC TACKLE DRYDOCK REPAIRS

Active

Contract Opportunity

The U.S. Coast Guard is looking for sources which would be interested in performing DRYDOCK repairs for Coast Guard Cutter TACKLE (WYTL 65604).

USCGC TACKLE (WYTL 65604) is a 65 Foot Small Harbor Tug.

ANTICIPATED PERIOD OF PERFORMANCE: The performance period of this upcoming DRYDOCK is 21 October 2025 to 15 December 2025.

The scope of the acquisition is for the drydock repairs of various work items for the USCGC TACKLE. This work will include, but is not limited to:

Fire Prevention Requirements TYPE

Hull Plating, U/W Body, Inspect

Hull Plating, U/W Body, Ultrasonic Testing

Hull Plating, Freeboard, Ultrasonic Testing

U/W Body, Preserve, 100 percent

U/W Body, Preserve, Partial, Condition A

U/W Body, Preserve, Partial, Condition B

U/W Body, Preserve, Partial, Condition C

Hull Plating Freeboard, Preserve, Partial

Hull Plating Freeboard, Preserve, 100 Percent

Hull and Structural Plating, General, 10.2 lbs. Steel, Renew

Hull and Structural Plating, General, 12.75 lbs. Steel Plate, Renew

Hull and Structural Plating, General, 15.3 lbs. Steel Plate, Renew

Hull And Structural Plating, General, 20.4 lbs. Steel Plate, Renew

Hull and Structural Plating, General, 7.5 lbs., 3/16 in. Steel Plate, Renew

Hull and Structural Plating, General, 7.65 lbs. Steel Plate, Renew

Hull And Structural Plating, General, Cracked Steel Welds, Repairs

Hull and Structural Plating, General, Degraded Weld, Steel, Repair

Appendages, U/W, Leak Test

Appendages, U/W, Internal, Preserve

Voids (Accessible, Weather Deck Exposed), Inspect

Tanks, MP Fuel Service, Clean and Inspect - Tender

Tanks, Potable Water, Clean and Inspect

Propulsion Shafting, Strain Gage Alignment, Inspect

Propulsion Shafting; Remove, Inspect, and Reinstall

Propulsion Shafting, Straighten

Propulsion Shaft Bearings, External, Check Clearances

Propulsion Shaft Bearings (External), Renew

Stern Tube Interior Surfaces, Preserve, 100 Percent

Propeller , Clean And Inspect

Propeller , Remove, Inspect, and Reinstall

Propeller, Minor Repairs and Reconditioning, Perform

Keel Coolers, Clean, Inspect and Hydro

Main Diesel Engine, MDE, Exhaust Piping, Commercial Clean

Ship Service Diesel Generator, SSDG, Exhaust Piping, Commercial Clean

Boiler Exhaust Stack Uptakes, Commercial Clean

Fathometer Transducer, Renew

Vent Ducts, Engine And Motor Room, All, Commercial Cleaning

Sea Valves and Waster Pieces, Overhaul Or Renew

Sea Strainers, Duplex, All Sizes, Overhaul

Hot Water Accumulator Tanks, Clean and Inspect

Compressed Air Receivers and System Valves, All, Clean, Inspect,

Hydro and Lift

Rudder Assembly, Remove, Inspect And Reinstall

Rudders, Preserve, 100 Percent

Rudder Stock Bearings Clearances, Check

Rudder Stock, Rebuild

Hull Fittings (Mooring and Towing), Inspect and Test

Boat Davit, Inspect and Service

Sewage Holding Tanks, Clean and Inspect

Grey Water Piping, Clean and Flush

Sewage Piping, Clean and Flush

Tanks (Sewage Holding), Preserve, Partial

Tanks, Potable Water, Preserve, Partial

Cathodic Protection, Zinc Anodes, Renew

Drydock

Temporary Services, Provide - Tender

Sea Trial Performance, Support, Provide

Bilges, Preserve

Deck Covering, Interior, Wet and Dry, Renew

Lead Dust, Clean

Ship Structures, Inspect for Presence of Lead-Based Paint

Lead-Based Paint and Asbestos-Containing Material, Perform Partial Abatement

Lead-Based Paint and Asbestos-Containing Material, Perform Spot Abatement

Lead-Based Paint, Perform Spot Abatement

Alarms, Halon Pre-discharge, Modify

Small Boat Cradle, Preserve

Cargo Hold Structural Repair

Frame Repair Crews Berthing

Multi-Cable Transit, Renew

Multi-Cable Transit Engine Room, Renew

Sewage System Piping, Renew

Emergency Lighting Fixtures, Replace

Companies which would be interested in submitting a proposal for this requirement should reply to this sources sought notice noting their business size status such as large business, small business, HUBZone, Service-Disabled Veteran-owned, Women Owned Small Business etc….

Replies should be sent by 11 July 2025, 10:00 am Eastern Standard Time to: Iran.N.Walker@uscg.mil

Shortly after receiving responses the Coast Guard will determine if this requirement will be set aside or unrestricted. After the determination a combined synopsis/solicitation will be posted on this website (https://www.sam.gov).

The NAICS Code is 336611. The small business size standard is less than 1300 employees.

Contractors are reminded that in the case of a HUB Zone set-aside, FAR 52.219-3, "Notice of HUBZone Set-Aside or Sole Source Award" would apply which requires that at least 50 percent of the cost of personnel for contract performance be spent for employees of the concern or employees of other HUBZone small businesses. Contractors are also reminded that in the case of a Service-Disabled Veteran-Owned Small Business Set-Aside, FAR 52.219-27, "Notice of Service-Disabled Veteran-Owned Small Business Set-Aside" would apply which requires that at least 50 percent of the cost of personnel for contract performance be spent for employees of the concern or employees of other service-disabled veteran owned small businesses.

Additionally, regarding FAR 52.219-30 "Notice of Set A-Side For Women-Owned Small Business Concerns…": A women-owned small business (WOSB) concern eligible under the WOSB Program, means a small business concern that is at least 51 percent directly and unconditionally owned by, and the management and daily business operations of which are controlled by, one or more women who are citizens of the United States.

Primary Point of Contact:

Iran Walker,

Iran.N.Walker@uscg.mil

Phone: (757) 628-4563

Attachments/Links