Coordinate Measuring Machines for Depot Level Maintenance on T408 Engine

UPDATE TO AMENDMENT 0002: RFP N68335-25-R-0269-0002 was inadvertently omitted from the last solicitation update. It has now been uploaded to this posting

***End Update to Amendment 0002***

Amendment 0002 is for the purpose of providing additional photographs of the installation site, making a few minor administrative corrections to the RFP, and providing additional instructions related to electronic proposal submission. All other information remains unchanged, and the closing date is not extended at this time.

***End Changes for Amendment 0002***

Amendment 0001 is for the purpose of providing answers to potential offerors' questions. All other information remains unchanged, and the closing date is not extended at this time.

***End Changes for Amendment 0001***

The Naval Air Warfare Center Aircraft Division, is officially releasing a Request for Proposal (RFP) as an unrestricted competition. This solicitation is for the procurement of two (2) Moving Bridge Coordinate Measuring Machines (CMMs) for the measurement of General Electric T408 Jet Engine Compressor Rotors and Stators in accordance with the attached Solicitation N68335-25-R-0269. For access to the Government provided documents associated with this solicitation, please send a request with an approved DD2345 via E-Mail to the address shown below no later than 4 pm Monday, 27 January 2025 referencing this post and requesting access.

Interested Offerors must be U.S. Government contractors and/or U.S. DoD contractors. Contractors must be registered in the System for Award Management (SAM) database, which can be accessed at www.sam.gov.

All responsible sources are encouraged to submit required information for this effort as described in the RFP.

The response date for proposal submission is 12:00 PM EST, 20 February 2025.

The point of contact is Tammy Fossa, tamara.d.fossa.civ@us.navy.mil. All questions and inquiries regarding this solicitation shall be submitted via E-Mail. Questions must be submitted no later than 4 pm 31 January 2025.