Furniture Systems and Carpet Replacement - Data Center Ogden

Scope. Contractor shall provide and install through purchase, delivery, and installation - new systems furniture, and carpet - as described in this PWS and as shown on the Design Intent Drawings (Appendix A). Work shall occur throughout various administrative and office areas of Data Center Ogden, which will remain in operation during the project. Phasing of Contractor’s operations will be required to minimize the impact on DISA’s mission. Approximately one-half of the various types of spaces (private offices, open offices, conference rooms, etc.) will need to be available at any phase of the project.

Task 1 - Project Management. Project Schedule, Existing Conditions, Submittals, General Requirements.

Task 2 – Electrical and Communication Systems. Prior to removal of furniture, disconnect electrical and communication systems from workstations and demountable partition. After installation of new carpet tiles and furniture, connect new workstations and print stations to electrical and communication systems.

Task 3 - Furniture demolition. Remove existing furniture, cubicle workstations, semi-private offices, and demountable partition per PWS, and the Design Intent Drawings (Appendix A). This task includes disconnection of electrical and communication systems from the workstations and demountable partition.

Task 4 – Carpet and Wall Base Replacement. Remove existing carpet tiles and wall base. Install new carpet tiles and wall base. Work shall be per the PWS, the Design Intent Drawings (Appendix A), and DISA’s Carpet Tile Specification (Appendix G).

Task 5 – Furniture Installation. Install new furniture; workstation cubicles, semi-private offices, seating, etc.) per the PWS, the Design Intent Drawings (Appendix A), and the Furniture Installation and General Requirements (Appendix B). This task shall include connecting the workstations to electrical and communication systems to provide fully operational workstations.

Task 6 - Project Close-Out. Provide spare materials and documentation.

Accessing Protected Proposal Documents:

The Access Request Link is located below Attachments/Links header.

If you cannot request RFP HC102825R0039 protected document access:

-Are you logged into SAM?

-Are you a registered SAM Point of Contact within your organization?

-Is your organization represented by NAICS 337214?

-Is your organization a certified Service Disabled Veteran-Owned Small Business, SDVOSB?

RFP HC102825R0007 issuing office has limited to zero assistance ability with SAM registrations. Please visit https://sam.gov/help for SAM registration support.

Allow up to 5 days before attempting to access controlled documents for recently updated SAM registrations. Allow at least 2 weeks before attempting to access controlled documents for new SAM registrations.