COUNTY OF HUMBOLDT
DEPARTMENT OF AVIATION
NOTICE TO BIDDERS
Sealed
proposals will be received by (and all bids should be mailed or delivered to) the
Department of Aviation
SEALED BID for Bid No 24146
County of Humboldt
Department of Aviation
3561 Boeing Avenue
McKinleyville, California, 95519
until 2:00 p.m., PDT, June 18, 2025, at which time they will be publicly opened by the Department of Aviation of the County of Humboldt at a public meeting located at the upstairs conference room in the Airport Terminal Building at 3561 Boeing Avenue, McKinleyville, CA for performing work as follows:
RUNWAY SAFETY AREA IMPROVEMENTS; REPLACE CULVERT
AIP NO. 3-06-0092-0xx-2025 | BID NO. 24146
Bids are required for the entire work as described herein:
The work to be done consists of replacing the drainage culvert on the south end of runway 36. Bidders are advised that the work must be completed within seven (7) calendar days. The Engineer's Estimate for this work is: $100,000
Plans, Special Provisions and Proposal Forms may be viewed at the Humboldt County Department of Aviation, 3561 Boeing Avenue, McKinleyville, California, 95519 and on the County’s website at: http://humboldtgov.org/Bids.aspx.
To receive electronic bid documents and to register as a plan-holder, prospective bidders must email a request to the following project contact: Department of Aviation Office,
For security reasons, you must enable JavaScript to view this E-mail address.
, (707) 839-5401. Failure to register as a plan-holder with Department of Aviation may result in a nonresponsive bid.
Printed copies of the contract documents may be obtained by prospective Bidders upon ADVANCE payment of a non-refundable printing and service charge in the amount of $100.00. All checks shall be made payable to COUNTY OF HUMBOLDT and should be mailed along with the request for Plans to the Humboldt County Department of Aviation, 3561 Boeing Avenue, McKinleyville, California, 95519.
Telephone: (707) 839-5401 Department of Aviation, questions regarding plans or specs and requests for plans or planholder list
Provisions that reference federal-aid contracts are applicable.
The successful Bidder shall furnish a Payment Bond and a Performance Bond.
The Contractor shall possess a
CLASS "A” Contractors License at the time this contract is awarded.
A non-mandatory pre-bid meeting will be held at Garberville Airport on June 11, 2025 at 9:00 a.m., PDT. All bidders are advised to examine the site to become familiar with all site conditions.
This contract is subject to state contract nondiscrimination and compliance requirements pursuant to Government Code, Section 12990. The County of Humboldt affirms that in any contract entered into pursuant to this advertisement, Disadvantaged Business Enterprises, as defined in 49 CFR Part 26, will be afforded full opportunity to submit bids in response to this invitation.
For this contract, the County has included a Disadvantaged Business Enterprises (DBE) goal of 3.16%. Bidders need not achieve the percentage stated as a condition of award.
For this contract, the number of trainees or apprentices for the Federal training program is 0 (zero)
Inquiries or questions based on alleged patent ambiguity of the plans, specifications or estimate
must be communicated as a bidder inquiry prior to bid opening. Any such inquiries or questions, submitted after bid opening, will not be treated as a bid protest.
Pursuant to Section 1773 of the Labor Code, the general prevailing wage rates in the county, or counties, in which the work is to be done have been determined by the Director of the California Department of Industrial Relations. These wages are set forth in the General Prevailing Wage Rates for this project, available at County of Humboldt, 3561 Boeing Avenue, McKinleyville, CA 95519 and available from the California Department of Industrial Relations’ Internet web site at http://www.dir.ca.gov/DLSR/PWD. The Federal minimum wage rates for this project as predetermined by the United States Secretary of Labor are available on the web home page of the Department of Labor at
https://sam.gov/content/wage-determinations
and copies may be examined at the offices described above where project plans, special provisions, and proposal forms may be seen. Addenda to modify the Federal minimum wage rates, if necessary, will be issued to planholders that have purchased bid documents from the Department of Aviation at 3561 Boeing Avenue, McKinleyville, California, 95519. Future effective general prevailing wage rates which have been predetermined and are on file with the California Department of Industrial Relations are referenced but not printed in the general prevailing wage rates.
Attention is directed to the Federal minimum wage rate requirements of the Department of Labor. If there is a difference between the minimum wage rates predetermined by the Secretary of Labor and the general prevailing wage rates determined by the Director of the California Department of Industrial Relations for similar classifications of labor, the Contractor and subcontractors shall pay not less than the higher wage rate. The Department will not accept lower State wage rates not specifically included in the Federal minimum wage determinations. This includes "helper" (or other classifications based on hours of experience) or any other classification not appearing in the Federal wage determinations. Where Federal wage determinations do not contain the State wage rate determination otherwise available for use by the Contractor and subcontractors, the Contractor and subcontractors shall pay not less than the Federal minimum wage rate which most closely approximates the duties of the employees in question.
This project is subject to the "Buy America" provisions of the Surface Transportation Act of 1982.as amended by the Intermodal Surface Transportation Efficiency Act of 1991 (ISTEA) Sections 1041(a) and 1048(a), and the regulations adopted pursuant thereto.
BUY AMERICAN PREFERENCE
(Title 49 USC § 50101, Executive Order 14005, Ensuring the Future is Made in All
of America by All of America’s Workers, Bipartisan Infrastructure Law
(Pub. L. No. 117-58), Build America, Buy America (BABA))
Certification of Compliance with Buy American Preference Statement
FAA Buy American Preference
The Contractor certifies that its bid/offer is in compliance with 49 USC § 50101, BABA and other related Made in America Laws,
1
U.S. statutes, guidance, and FAA policies, which provide that Federal funds may not be obligated unless all iron, steel and manufactured goods used in AIP funded projects are produced in the United States, unless the Federal Aviation Administration has issued a waiver for the product; the product is listed as an Excepted Article, Material Or Supply in Federal Acquisition Regulation subpart 25.108; or is included in the FAA Nationwide Buy American Waivers Issued list.
The bidder or offeror must complete and submit the certification of compliance with FAA’s Buy American Preference, BABA and Made in America laws included herein with their bid or offer. The Airport Sponsor/Owner will reject as nonresponsive any bid or offer that does not include a completed certification of compliance with FAA’s Buy American Preference and BABA.
The bidder or offeror certifies that all constructions materials, defined to mean an article, material, or supply other than an item of primarily iron or steel; a manufactured product; cement and cementitious materials; aggregates such as stone, sand, or gravel; or aggregate binding agents or additives that are or consist primarily of: non-ferrous metals; plastic and polymer-based products (including polyvinylchloride, composite building materials, and polymers used in fiber optic cables); glass (including optic glass); lumber; or drywall used in the project are manufactured in the U.S.
1
Per Executive Order 14005 “Made in America Laws” means all statutes, regulations, rules, and Executive Orders relating to federal financial assistance awards or federal procurement, including those that refer to “Buy America” or “Buy American,” that require, or provide a preference for, the purchase or acquisition of goods, products, or materials produced in the United States, including iron, steel, and manufactured products offered in the United States.
