USAFA Infrared Single Frequency Laser System

ATTENTION: Amendment 1, dated 21 July 2025 is posted on 22 July 2025,. Amendment 2, dated 26 August 2025 is posted on 26 August 2025. Amendment 3, Dated: 28 August 2025 is posted on 28 August 2025. Amendment 4, Dated: 3 September 2025 is posted on 3 September 2025, attached Request for Information responses to SAM.gov posting

The purpose of this combined synopsis and solicitation is for the purchase, delivery, and installation of one Infrared Single Frequency Laser System.

The Contractor shall supply all labor, material, freight/transportation, equipment, and supervisions to install the infrared Single Frequency Laser System in accordance with the following salient characteristics. The contractor is responsible for ensuring the product is complete and usable upon installation to include all appropriate electrical connections. The Government will ensure that the intended installation location is free of obstacles, allowing the contractor the necessary space to install the requested laser system. The contractor will ensure the site is clear prior to acceptance by the Government.

SALIENT CHARACTERISTICS/REQUIRED SPECIFICATIONS

At minimum, an Infrared Single Frequency Laser System to provide optimal benefit includes the following salient characteristics:

• Single frequency tunable single mode laser system


• Must be continuous wave (cw)


• Must be all solid state and/or fiber laser system


• Laser output in 515 - 660 nm range with power output of at least 25 mW over the entire range


• Laser linewidth less than 150 kHz


• Single mode continuous scan range of at least 20 GHz


• Single set of optics for the entire output wavelength range


• Lntensity noise less than 0.4 % RMS over 10 kHz to 10 MHz band


• Lntegrated pick off and fiber launch module for stable connection to a wavemeter


• 110 VAC power supply


• US type power plug


• Training and installation included


• Warranty


• Must be new


• Delivery F.O.B. Destination to USAF Academcy, CO 80840

See attachments for additional information